Spectacular Exhaust Fan And Light On Same Switch

The switch allows you to work safely on the fan without turning off power to the entire house and lets you turn it off temporarily if the fan ever breaks while still being able to use the light.

Exhaust fan and light on same switch. Maybe a little bit elaborate but here s the lineup. The main light is a very bright led. The isolator would typically be located high up on a wall or in the ceiling out of reach of bumps and splashes and less intrusive visually.

Twist the ground wires together and connect them to the green ground screw on the switch. If running a wire from the light box is difficult you can add an extra box between the existing switch and the light that can feed both the light and the fan from the existing switch wire. Both were in the attic so it was easy to run a wire from the light to the fan.

Grip these in your non dominant hand while you twist the ends clockwise. If the fan and the lights are on the same load line then all you can do is on off of the lights. If you re willing to separate them then you can have the lights dim and the fan as an on off so then it becomes a question of what physical devices do you want at the switch and is it a single gang or a double gang.

Splice the white wires together and cap them. Connect the black fan cable together with the black light wire and the black switch wire and cover them. By splicing the ground wires you don t have to cover them but it s still a good idea to do it because the lid helps keep them together.

6 wires are coming in. The key factor is to understand where the power source enters the circuit. How to wire your bathroom so the lights and fan are on separate switches the electrical wiring for separate switching of the bathroom exhaust fan and the light fixture will require identifying the existing circuit and existing switch wiring.

Use the red wire in the 3 conductor cable to put the light and fan on different switches. Mount the fan and light and move to the switch box. Connect the white wires in the same way then repeat with the ground wires.