Great Wiring A Toggle Light Switch

The neutral wire from the source is spliced to the white cable wire and continues on to the light.

Wiring a toggle light switch. Do not touch the wires. Use a female spade connector to make the connection if your switch has blade terminals and a ring terminal connector if the switch has screw terminals. Step 1 locate a fused line as near as possible to the proposed location for the toggle switch using a test light.

Connect the wire from your power source to the center terminal of the switch. Generally used in 12vol. Applies to spot switches non led switches basic 2 wire switches 2 prong.

The source is at the switch and 2 wire cable runs from there to the light. Make sure you don t attach the traveler wires to the common screw or else the switches won t work properly. Use a circuit tester to test all of the wires in the junction box.

The 3 is used by the ground for the switch lights and the 6 is used by the blue switch light wire. How to wire 2 way light switch in this video we explain how two way switching works to connect a light fitting which is controlled with two light switches. Here a single pole switch controls the power to a light fixture.

Use the existing 2 wire conductor leading from the light to the switch. If none of the wires have power with the light switch turned off then you do not have a switch leg and this post pertains to your wiring. Learn how to wire a toggle switch in just a couple minutes.

How to wire aux lights fog lights led lights light bar or anything else to a switched circuit in your vehicle the right way. At the light the white wire connects to the neutral terminal and the black wire connects to the hot. The source hot wire is connected to a switch terminal and the other terminal is connected to the black cable wire.